PP Magnetic Pump NP-60
● Pump Type – Centrifugal, Magnetic Drive, Non Self Priming Pump
● Pump Material – PP (Polypropylene)
● Shaft – Ceramic
● O’Ring, Bush & Bearing – Viton, GFT (Glass filled Teflon), Carbon
● Media – Diluted Acidic Solution
● Max Liquid Density – 1.3
● Max Head – Upto 7 Meter
● Max Flow – 60 Leter per Minute
● Inlet & Outlet – 20 mm x 20 mm (Nozzle / Threaded)
● Motor Specification – 0.25 HP, NFLP, 2800 RPM, 50 Hz, 1 Phase or 3 Phase
● Magnet – High Power Permanent Rare earth Magnets
● Fluid Temperature – 70° C (Max)
● Seal Type – Sealless
● Impeller – Semi Open Type
Our range of PP Magnetic Drive Pumps
PP Magnetic Pump
We are leading PP Magnetic Pump Manufacturers in Gujarat India. When aggressive or dangerous liquids, unusual materials, acids, alkalis, corrosives, pollutants, and toxics are pumped, pp magnetic pumps are frequently employed. PP Magnetic Pump are also utilised for ultra-pure liquids and liquids that are difficult to seal. To keep hazardous/challenging substances from escaping to the atmosphere, sealed pumps used in these sorts of services may leak over time or require complicated, expensive double seals, which can result in safety issues, downtime, and higher maintenance costs.
Difficult liquids are another major use for pp magnetic pump; for example, some liquids can crystallise on seal faces, resulting in seal failures. A permanent flush system should be run to the seal to avoid this. However, this can raise maintenance costs, seal flushing liquids, and energy use. A pp magnetic pump is a superior choice for these demanding services.
What is magnetic pump?
Because there is no direct connection between the electric motor shaft and the impeller in pp magnetic pump, no seal is required. Unless the pump casing is cracked, there is little chance of leaking. Pump excursions and unplanned shutdowns are known to be caused by seals. Seals are obviously a significant increase in pump performance, dependability, and availability. Liquids may be pumped without spilling since the possibility of leakage is fully avoided. Eliminating the seals also eliminates the friction loss, wear, expenses, and noise that come with them. This allows for total separation of the liquid from the pump drive and improved motor power transmission to the pump. Because the pp magnetic pump chamber is fully separated from the electric motor by a huge air gap, there is virtually no heat transfer from the electric motor; this creates an effective barrier between the two. Any shock or spike torques will be softened by the magnetic coupling. It will operate as a fuse even in the most severe scenarios. If the pump’s load is too large, magnetic connections can be momentarily severed. In reality, this implies that the pp magnetic pump will not get overloaded and destroyed.